Our Work

Replaced a dated Challenger electrical panel with a new code-compliant load center — reorganized circuits, cleaned up wiring, and restored safe breaker protection.

Full Lutron lighting control system with multiple distribution panels, relay modules, and structured low-voltage wiring for a new construction home — rough-in through final termination.

Custom grid of oak wood accent panels with integrated LED tape lighting behind each frame — from rough-in and panel layout through a finished backlit feature wall with centered TV mount.

Prepared and wired a complete home theater system with KEF Ci160QL in-wall speakers, a Denon AV receiver, and structured low-voltage wiring throughout the living room — from equipment staging through a clean finished install.

Wall-mounted televisions on brackets throughout the home — dedicated outlets placed for hidden power, in-wall cabling for a cordless look, and full TV setup including network and soundbar integration.

Complete kitchen lighting install — woven island pendants over the marble countertop, undercabinet LED along the backsplash, and interior lighting inside every glass-door upper cabinet.

Full bathroom lighting package for a luxury remodel — vanity sconces flanking the mirrors, a center chandelier, recessed LED throughout, and backlit lighted mirror installations wired and mounted during construction.

Installed a modern textured wall sconce in a blue-accent hallway and a sculptural LED chandelier centered over a marble dining table — wiring, mounting, and switch integration.

Custom LED tape lighting behind a geometric black accent wall creates a warm, architectural glow in the customer's foyer entrance — dimmable, low-profile, and professionally wired.

Integrated LED tape lighting along closet shelving, hanging areas, and the center island toe-kick — highlighting storage zones and adding a luxury finish to a custom walk-in closet.

Transformed a baby's room with paired wall sconces, black board-and-batten wainscoting, and custom ELIAS wall lettering — from bare walls through installation to a warm, finished nursery.

Installed modern black outdoor sconce fixtures on a textured concrete block stucco wall — new wiring, weather-rated boxes, and clean mounting for garage entrance lighting.

GEM Remotes control system on a waterfront dock piling — weatherproof receiver, GFCI outlet, dock disconnect switch, PVC conduit runs, and fully wired boat lift motors.

Installed two GEM remote control systems for separate boat lifts on the same dock — motor wiring, lighting outlets, PVC conduit, GFCI protection, and NO SWIMMING shock hazard signage.

Replaced an exposed, non-code-compliant dock panel with a weatherproof subpanel, PVC conduit run, GFCI-protected outlets, and boat lift controls — permitted and inspected.